Design of Composites with a Specified Set of Physicomechanical Properties Using Three Control Parameters

Статья в журнале

Previously, an algorithm based on two control parameters was applied to computer aided design of materials, and here the algorithm is extended to three parameters controlling the effective physicomechanical properties of polymer matrix composites: (i) the average particle size of a polymer powder, (ii) the length of reinforcing fibers, and (iii) the level of fiber–matrix adhesion. The use of these control parameters is dictated by the possibility of their ranging in terms of degrees of influence on effective material characteristics. The algorithm with built-in experimental data is applied to design a composite with specified properties on the example of ultrahigh molecular weight polyethylene reinforced with milled or chopped glass fibers. The form of data presentation shows the whole range of the three parameters which provides the desired result.

Журнал:

Physical Mesomechanics
Pleiades Publishing (Road Town)
Индексируется в Scopus

Библиографическая запись: Design of Composites with a Specified Set of Physicomechanical Properties Using Three Control Parameters [Electronic resource] / S. A.Bochkareva [et al.] // Physical Mesomechanics. – 2021. – Vol. 24. – Iss. 2. – P. 196-201. – DOI: 10.1134/S1029959921020090

Ключевые слова:

COMPUTER AIDED DESIGN CONTROL PARAMETER EFFECTIVE CHARACTERISTICS POLYMER MATRIX COMPOSITES SPECIFIED PROPERTIES

Индексируется в:

Авторы: Бочкарева С. А., Гришаева Н. Ю., Люкшин Б. А., Панов И. Л., Панин С. В.

Год издания: 2021

Страницы: 169 - 201

Язык: Английский

DOI: 10.1134/S1029959921020090